Because they offer maximum flexibility, most reloaders start their collection of Bench Rest® dies with full length sizers. But, if you're loading for the same firearm, it's not necessary to use the entire capacity of your full length sizer each time you reload. A fire formed case matches the chamber from which it was ejected and should only require that the case be partially sized to accurately align in your firearm's chamber. Simply back off the full length sizer die counter-clockwise in the press so the die is about 1/8 inch from the shell holder when the ram is at the top of the stroke. Refer to the fine tuning instructions in your Bench Rest® die set for more information about producing ammunition that has a "glove fit" to your chamber. This procedure allows you to use your full length sizer to partially resize your cases. After approximately five to ten firings, the brass flow that has occurred will again require full length resizing. Full length dies are available in more than fifty calibers, either individually or as a set with one of our Bench Rest® seater dies.

SEE ORDERING CHART.

Reloading Die Replacement Parts List

Loading Dies Price List