The "Original" Case Graphiter

When sizing a fired case, pulling the expander button through the inside diameter of the case can present a problem because residual deposits left from firing can create friction when the expander is withdrawn. In a worst case scenario, that friction can cause distortion or stretching of the case neck. Proper lubrication of your case necks is the answer, but oils are not recommended because of the very real possibility of gunpowder contamination. The Forster Case Graphiter is constructed of tough, impact resistant plastic and the base is drilled to permit permanent mounting to a loading bench. Three brushes are mounted in the base. They will accommodate all calibers from .22 to .35. The Case Graphiter comes with enough white “motor mica” to process 2000-3000 cases. By moving the case neck up and down on the correct graphite-covered brush, the neck can be cleaned and lubricated at the same time. A cover is also included to keep dust and grit from contaminating the white graphite.

It is best to keep the graphite (mica) wiped off of the outside diameter of case necks when resizing brass.

Order No.
011341	Case Graphiter
011341-012	Extra Powdered Graphite (White Motor Mica)
011341-013	Extra Nylon Brush, .22 Cal.
011341-014	Extra Nylon Brush, .270 Cal.
011341-015	Extra Nylon Brush, .35 Cal.

	Original Case Neck Graphiter Component Price List
	Reloading/Handloading Tools & Accessories Price List