Outside Neck Turner

VIDEO! NECK TURNER SETUP (Cam Follower Insertion)
VIDEO! NECK TURNER SETUP (Proper Case Alignment)
VIDEO! NECK TURNER SETUP (Proper Cutting Control)

The Forster Outside Neck Turner is an invaluable aid in maintaining a uniform thickness in the neck walls of your cartridge cases. Why is that important? Here's what The American Rifleman says:

"Case necks thicken from repeated firing. This condition may prevent the neck from expanding properly to release your bullet. This lack of neck clearance leads to inaccuracy and has even blown up some fine rifles over the years."

Unlike hand held neck turners which are centered only on the pilot, the Forster Outside Neck Turner turns your case neck concentric to its true axis. It produces neck walls of uniform thickness and exact outside neck diameter. Properly adjusted, it will turn necks to within a tolerance of .0001". The cutter head of the Outside Neck Turner has an adjustable circular carbide cutter for a lifetime of reliable use. In operation, the wall of the neck passes progressively between the pilot and the cutter, as the neck wall of the case is reduced to a uniform thickness. You control the rate of feed by rotating the feeder cam while a mechanical stop controls the length of the cut. The short pilot used in case trimming is replaced with a longer, hardened and ground pilot of the desired caliber. To change calibers (any diameter from .204 to .375) simply insert the correct pilot and make the necessary adjustments. NOTE: The Forster Outside Neck Turner is designed to be used after the neck has been resized and expanded. Cases longer than .375 Magnum (2.94") require a long case trimmer base. Please note that pilots for this tool are not interchangeable with pilots for our Hand Held Outside Neck Turner.

Order No.
OT1010	Outside Neck Turner
ONT400	Spare Carbide Cutter
ONT417	Spare 17 Cal. Carbide Cutter

	Outside Neck Turner Component Parts Price List
	Case Trimmer Accessories & Add-Ons Price List